Part VII · Layout in depth

The Art of Analog Layout

The craft of turning a schematic into silicon that works: what each layer and rule means, how wires and junctions fail, how to draw resistors, capacitors, bipolar transistors and large devices, how to make devices match, how to protect a chip from electrostatic discharge, and how to assemble a die. Every layout and figure is drawn in SG13G2 and SKY130 with the course's open tools.

This part follows the scope of R. A. Hastings's The Art of Analog Layout [61], the standard text on the subject, re-developed for two open processes. The explanations, layouts and simulations are our own; read Hastings for the depth that a web course cannot hold.

Chapter 23

Layout Fundamentals: From Masks to Rules

A layout is a set of masks. Knowing what each drawn layer becomes in SG13G2 and SKY130, and why every design rule exists, is the base of all analog layout craft.

Chapter 24

Reliability: Electromigration, Latch-up and Antennas

A circuit that simulates perfectly can still fail in the field: wires wear out under current, parasitic thyristors latch, and plasma charge breaks gate oxides during manufacture. Layout is where each of these is prevented.

Chapter 25

Resistors

Integrated resistors are rectangles of resistive film, and almost every way they deviate from their nominal value can be traced to their layout: contacts, width, temperature, voltage and the substrate beneath.

Chapter 26

Capacitors and Inductors

On-chip capacitors trade density against linearity and parasitics; on-chip inductors trade area against quality factor. The layout decides where on those curves a design lands.

Chapter 27

Matching in Layout

Two devices drawn the same are never the same on silicon. Random variation shrinks with area; systematic variation from gradients, stress and wells only shrinks with layout. This chapter is about the second kind.

Chapter 28

Bipolar Transistors and Diodes

Bandgap references, temperature sensors and protection circuits all need junctions. SG13G2 offers fast SiGe HBTs; SKY130 offers parasitic PNPs. How they are drawn decides how well they match.

Chapter 29

Power Devices, Guard Rings and ESD

Large transistors carry amperes through narrow metal, injected carriers wander far through the substrate, and a touch of a finger delivers kilovolts. All three are layout problems.

Chapter 30

Assembling the Die

The last step turns blocks into a chip: estimate its area, plan its floor, build its pad ring, route its power and signals, and check it against a list of everything that goes wrong at tape-out.


Back to top

SkillSurf · The Art of Analog IC Design, draft v0.1 (November 2026). Every source is listed on the References page.

© 2025–2026 SkillSurf. Text, figures and 3D models: CC BY 4.0; code: MIT. The SkillSurf name and logo are not covered.

This course was written with the help of AI tools and may contain mistakes. If you find one, please tell us through SkillSurf or email skillsurfedu@gmail.com, and we will correct it.

This site uses Just the Docs, a documentation theme for Jekyll.